Add wasm tacle-bench targets

targets/wasm-tacle/parallel/DEBIE/code/arch/arm7-lpc2138-mam/cpulib.h

@@ -0,0 +1,51 @@
+/*
+  cpulib: Routines for CPU initialization and configuration.
+
+  Target  : iSYSTEM LPC2138-M minitarget board (ARM7TDMI)
+  Source  : iSYSTEM iF-DEV-LPC kit
+  Changes : Tidorum Ltd (N. Holsti)
+
+  $Id: cpulib.h,v 1.1 2008/04/08 09:44:55 niklas Exp $
+*/
+
+
+#ifndef CPULIB_H
+#define CPULIB_H
+
+#define REG(x) (*((volatile unsigned int *)(x)))
+#define IO0DIR      REG(0xE0028008)  // I/O direction control
+#define IO0CLR      REG(0xE002800C)  // output clear
+#define IO0SET      REG(0xE0028004)  // output set
+#define PLLCFG      REG(0xE01FC084)  // PLL Config Reg. 
+#define PLLCON      REG(0xE01FC080)  // PLL Control Reg.
+#define PLLFEED     REG(0xE01FC08C)  // PLL-Feed 0xAA, 0x55
+#define PLLSTAT     REG(0xE01FC088)  // PLL-Status register
+#define MAMCR       REG(0xE01FC000)  // MAM Control register
+#define MAMTIM      REG(0xE01FC004)  // MAM Timing register
+
+
+#define IO_LED    0x00000001
+// The LED is connected to pin P0.0.
+
+
+void cpulib_init_cpu ( void );
+// Initializes the processor (in addition to crt0 actions).
+// Defines the LED control pin (P0.0) as output and emits a "1"
+// to turn off the LED.
+
+void cpulib_go_fast ( unsigned int mode );
+// Sets the PLL to run the processor at 60 MHz.
+// Does not alter the MAM mode (because of the LPC2138 errata).
+
+void  cpulib_set_led ( int state );
+// Turns the LED on if state != 0, off if state = 0.
+
+void cpulib_flash_led ( void );
+// Turns the LED on for a brief time, then off.
+// Useful only if the LED is initially off.
+
+void cpulib_blink_led ( void );
+// Turns the LED off for short time, then on
+// for a shorter time, then off again.
+
+#endif