debuggers: import openocd-0.7.0

Initial check-in of openocd-0.7.0 as it can be downloaded from
http://sourceforge.net/projects/openocd/files/openocd/0.7.0/

Any modifications will follow.

Change-Id: I6949beaefd589e046395ea0cb80f4e1ab1654d55

debuggers/openocd/tcl/board/telo.cfg

@@ -0,0 +1,61 @@
+source [find target/c100.cfg]
+# basic register defintion for C100
+source [find target/c100regs.tcl]
+# board-config info
+source [find target/c100config.tcl]
+# C100 helper functions
+source [find target/c100helper.tcl]
+
+
+# Telo board & C100 support trst and srst
+# Note that libftd2xx.so tries to assert srst
+# which break this script
+# use libftdi.so library instead with this script
+# make the reset asserted to
+# allow RC circuit to discharge for: [ms]
+adapter_nsrst_assert_width 100
+jtag_ntrst_assert_width 100
+# don't talk to JTAG after reset for: [ms]
+adapter_nsrst_delay 100
+jtag_ntrst_delay 100
+reset_config trst_and_srst separate
+
+
+
+
+# issue telnet: reset init
+# issue gdb: monitor reset init
+$_TARGETNAME configure -event reset-init {
+	adapter_khz 100
+	# this will setup Telo board
+	setupTelo
+	#turn up the JTAG speed
+	adapter_khz 3000
+	echo "JTAG speek now 3MHz"
+	echo "type helpC100 to get help on C100"
+}
+
+$_TARGETNAME configure -event reset-deassert-post {
+	# Force target into ARM state.
+#	soft_reset_halt ;# not implemented on ARM11
+	echo "Detected SRSRT asserted on C100.CPU"
+
+}
+
+$_TARGETNAME configure -event reset-assert-post {
+  echo "Assering reset"
+  #sleep 10
+}
+
+proc power_restore {} { echo "Sensed power restore. No action." }
+proc srst_deasserted {} { echo "Sensed nSRST deasserted. No action." }
+
+
+# boots from NOR on CS0:  8 MBytes CFI flash, 16-bit bus
+# it's really 16MB but the upper 8mb is controller via gpio
+# openocd does not support 'complex reads/writes' to NOR
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
+
+# writing data to memory does not work without this
+arm11 memwrite burst disable